DIY: How to install an electric shower?

faucet

Learn with our step by step how to install an electric shower in a safe and uncomplicated way.
Your electric shower doesn’t heat up, usually gives small shocks or worse, does it smell like a burn? Then it was time to change it.

Many people prefer to hire a third party to carry out this task because they think it is a very difficult, complicated job. But it is not! Read on and see how easy it is to change and install an electric shower in a simple and safe way.

ATTENTION TO THE DETAILS!
Before purchasing your shower, check its voltage compatibility with the installation location. Furthermore, it is essential that the thickness of the wiring at the installation location is compatible with the thickness of the wires in the shower purchased. These details are very important to avoid overloads and short circuits.

For your safety, work with the appropriate epis, such as shoes with rubber soles and gloves. In addition, the ideal is that the ladder also has a rubber base, as well as its tools.

BEFORE STARTING:

Turn off the main switch or circuit breaker that corresponds to the installation environment. Then close the general water valve that feeds the shower pipe.

After that, turn on the shower valve to remove the accumulated water inside the shower pipe, then close it after all the water comes out.

Before handling the cables make a test with the Test Wrench or a Voltage Detector to make sure everything is turned off. Once this is done, we can continue the work. For Residential Plumbing  Consult Here

FIRST STEPS:

If you are changing your shower for another model, you will need to disconnect the cables and remove the old shower head and all the thread sealing tape that is attached to the pipe.

SEALING AND FITTING THE SHOWER:

In a clockwise direction, apply a new layer of thread sealant to the shower pipe (8 to 10 turns will be fine). This will prevent leaks.

Screw the shower head onto the wall pipe, leaving the water outlet location well-aligned vertically and downward. Avoid extra force so as not to damage the pipe and the product.

BEFORE STRIKING: UNDERSTAND THE CABLES:

For showers with 110V connection, we will have the following cables: neutral (blue), green (earth) and phase (red). According to the standard the phase cable can be white, black, red, and yellow, but never blue and green.

For 220V connection showers, we will have the following cables: earth (green) and 2 cables for the phase (following the same color standard). For Plumbing Consult Here

CONNECTING THE WIRES:

It’s time to strip the wires. Take the Bare Pliers or Universal Pliers and strip the 3 cables.

Take the porcelain connector and fit the wires, using screwdrivers or Philips to tighten.

#FG TIP: Use a porcelain connector instead of insulating tape splices, as the wiring heats up more frequently, which can melt the splices and cause greater damage to the electrical system.

FINISHING THE INSTALLATION:

With the cables connected and before turning on the shower valve, make sure the shower switch is set to the cold temperature option (shower off position).

Turn on the valve and let the water drain for approximately 1 minute to remove possible air bubbles from the plumbing and fill the reservoir in the shower diagram. How to unclog clogged pipe

IMPORTANT! Do not turn on the shower without water as, if this happens, the resistance will burn out.

After following these steps, just turn on the circuit breaker, choose the desired temperature option and notice that your shower will be working perfectly.

Related Articles

Leave a Reply

Your email address will not be published.